Ubi0: user volume: 1, internal volumes: 1, max. Ubi0: good PEBs: 1600, bad PEBs: 0, corrupted PEBs: 0 Ubi0: VID header offset: 2048 (aligned 2048), data offset: 4096 Ubi0: attached mtd1 (name 'ubifs2', size 200 MiB) Ubi0: volume 0 ('rootfs') re-sized from 1009 to 1436 LEBs => run bootcmd1 bootcmd2 bootcmd3 bootcmd4 NAND write: device 0 offset 0x0, size 0x7e60000 NAND erase.part: device 0 offset 0x0, size 0xc800000 => run Waiting for SGMII auto negotiation to complete. Turn_off_all_dsps#34: Called disabling DSP SF: Detected mt25qu256a with page size 256 Bytes, erase size 4 KiB, total 32 MiB spi_flash_std_probe: slave=fdf0bb98, cs=0 Relocating to fff46000, new gd at fdf05ed8, sp at fdf05eb0ĭevice found, Manufacturer ID: 0x2c, Chip ID: 0xb3 Now, if I configure u-boot with its SPL linux run on all ARM core in SMP mode (as client request). I have configured for our custom board a uboot u-boot-2019.01 (packet content into With some correction to able to start ARM and DSP application. I have found a little problem with out2rprc.exe, then I have used an opensource tool elf2rprc The used PDK is contents in ti-processor-sdk-rtos-k2hk-evm-05.02.00.10-Linux-x86-Install.bin To perform boot of DSPs and ARMs (together) our client want to use MLO (contents in TI PDK). We have a (another) little problem, now is about the SMP, our SOC architecture is K2H14.

Vxworks nand file system